P-250
67
Editing a Voice in Detail [VOICE EDIT]
Edit Operation
■
Setting the chorus depth* [ChorusSend]
Press the D [–]/[+] buttons to set the value (0—127).
■
Turning the chorus on/off [ChorusOnOff]
You can set the [CHORUS] button on or off for each voice.
When you select a voice, the voice automatically uses this
chorus on/off setting.
Press the D [–]/[+] buttons to turn On/Off.
■
Selecting the insertion effect type*
[Ins.Type(Ins)]
You can select other effects (than reverb and chorus).
Press the D [–]/[+] buttons to select one of the following:
Delay LCR .......... Delays the sound on left, center, and
right.
Delay LR............. Delays the sound on left and right.
Echo ................... Echo-like delay
CrossDelay ......... Left and right delays are crossed.
Symphonic ......... Adds a rich, deep dimension to the
sound.
Rotary................. Reproduces the vibrato effect of rotary
speakers.
Tremolo .............. The volume level changes in cycles.
VibeRotor ........... Vibrato effect typical of a vibraphone
AutoPan .............. Moves the sound left and right.
Phaser................. Changes the phase periodically to cre-
ate a swell.
AutoWah ............ Changes the center frequency of the
wah filter periodically.
SoundBoard ........ Creates reverberation that simulates a
piano sound board.
AmpSimulator..... Distortion effects
Off ......................No effect
■
Setting the speed of the vibraphone vibrato
effect* [VibeRotorSpeed(RotorSpeed)]
This parameter is displayed only if VibeRotor is selected
for the “Ins.Type” parameter.
This parameter enables you to set the speed of vibrato when
you select the Vibraphone voice and use a vibe rotor pedal.
Press the D [–]/[+] buttons to set the speed (1—10).
■
Turning the Vibraphone vibrato on/off*
[VibeRotorOnOff (RotorOnOff)]
This parameter is displayed only if VibeRotor is selected
for the “Ins.Type” parameter.
This parameter turns on/off the vibrato effect that is
applied when you use the VibeRotor pedal.
Press the D [–]/[+] buttons to turn the parameter On or Off.
■
Adjusting the speed of the rotary speaker*
[RotarySpeed (Rot.Speed)]
This parameter is displayed only if Rotory is selected for
the “Ins.Type” parameter.
This parameter sets the rotation speed of the rotary
speaker effect.
Press the D [–]/[+] buttons to simulate a speaker turning
Slow or Fast.
• Refer to page 61 for general information on setting the parameters.
• Refer to pages 3—5 of the separate “Data List” for information on the default parame-
ter settings.
• All parameters accessed via the [VOICE EDIT] button are performance parameters (page 30).
In Dual mode:
Voice for editing (Main part or Layer part)
TERMINOLOGY
Rotor = The rotating portion of an electric motor.
Summary of Contents for P-250
Page 56: ...MEMO 56 P 250 Edit Operation ...
Page 80: ...MEMO 80 P 250 Appendix ...
