The Function Mode
33
P-120/P-120S
31
F3.5: 1st Voice Effect Depth
....................................................................
F3.6: 2nd Voice Effect Depth
..................................................................
These functions make it possible to individually set the depth of the effect for the 1st and
2nd dual-mode Voices (“1st” and “2nd” is explained on page 18). Use the
[–/NO
▼
]
and
YES
▲
]
buttons to set the effect depth for the corresponding voice as required. The depth
range is from 0 through 20. A setting of “0” produces no effect, while a setting of “20” pro-
duces maximum effect depth. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to
recall the default setting (different for each voice combination).
• The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be
exited before EFFECT can be turned ON.
F3.7: Reset
...............................................................................................
This function resets all dual-mode functions to their default values. Press the
[+/YES
▲
]
button to reset the values. “
End
” will appear on the display when all functions have been
reset.
After selecting “
F4.Y
”, press the
[+/YES
▲
]
button to engage the split-mode function sub-
mode, then use the
[TEMPO/FUNCTION#
▼
,
▲
]
buttons to select the desired split mode
function, as listed below.
If the Split mode is not engaged “
F4.-
” will appear instead of “
F4.Y
” and the Split mode
functions cannot be selected. Also note that you must exit from the Function mode before the
Split mode can be engaged.
F4.1: Split Point
.......................................................................................
In addition to the split point setting method described on page 19, the split point can be set
via this function. Use the
[–/NO
▼
]
and
[+/YES
▲
]
buttons to set the split point as required, or
simply press the appropriate key on the keyboard: from “
A-1
” to “
C7
”. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to recall the default setting “F
#
2”.
F4.2: Split Balance
..................................................................................
The volume levels of the two voices combined in the split mode can be adjusted as required
by using this function. Use the
[–/NO
▼
]
and
[+/YES
▲
]
buttons to adjust the balance as
required. The balance range is from 0 through 20. A setting of “10” produces equal balance
between the two split-mode voices. Settings below “10” increase the volume of the Left Voice
in relation to the Right Voice, and settings above “10” increase the volume of the Right Voice
in relation to the Left Voice. Press the
[–/NO
▼
]
and
[+/YES
▲
]
buttons simultaneously to
recall the default setting (different for each voice combination).
• The split balance setting is set individually for each voice combination.
■
SHORTCUT:
You can jump directly to the split-mode functions (F4) by pressing the
[TEMPO/FUNCTION#]
button while holding the
[SPLIT]
button.
NOTE
F4
: Split Mode Functions ____________________________
NOTE
