CONNECTIONS
• Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of the
receiver.
Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect
the (−) terminals on both components using the other side of the cable.
•
•
How to connect
1 Press and hold down the speaker terminal.
2 Insert the bare wire.
3 Release the terminal. Test the firmness of the
connection by pulling lightly on the cable at the
terminal.
Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
Notes:
• Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.
• Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals,
making sure no to reverse the polarity (+, −). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
Receiver
NS-IW560C
•
When using a banana plug
Insert the banana plug into the top of the
terminal as shown below:
1
Banana plug
+ −
−
+
Black (−)
Red (+)
(−)
(+)
1
2
1
6
