Yamaha NS-BP112, Owner'S Manual

Page: 5 / 62

4
En
English
Before making connections, make sure that the amplifier is switched off.
■
How to connect the speaker cables
NOTICE
• Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.
• When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be
taken never to exceed the speaker’s maximum input.
• The speaker may be damaged if certain sounds are continuously output at high volume level. For example, if sine waves
from a test disc, bass sounds from electronic instruments, etc., are continuously output, or when the stylus of a turntable
touches the surface of a disc, reduce the volume level to prevent the speaker from being damaged.
NOTE
• Do not insert the insulation coating into the hole. The sound may not be produced.
• Connect the (+) terminals on the amplifier and the speakers using one side of the cable. Connect the (–) terminals on
both components using the other side of the cable.
• Connect the speakers to the left (L) and right (R) terminals of your amplifier, making sure not to reverse the polarity (+,
–). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.
• Please refer to the owner’s manual that came with your amplifier or receiver.
Connecting to your amplifier
1
2
2
3
4
1
Speaker (R) Speaker (L)
Speaker output terminal
Amplifier
When using a banana plug
Banana plug
1
Remove 15 mm (5/8") of insulation from each end of the cables,
and twist the exposed conductors together neatly and tightly, as
shown left.
2
Loosen the terminal knob.
3
Insert the bare wire.
4
Tighten the knob and secure the cable.
5
Test the firmness of the connection by pulling lightly on the cable
at the terminal.
15 mm
(5/8")
Good No Good