3
En
Removing / Attaching the grille
English
■
When using a banana plug
The grille is attached to protect the speaker unit, but you can remove it if necessary.
To remove the grille, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four
holes on the inside surface of the grille with the four corresponding pegs on the speaker and push gently.
Type
.................................................................... 2-way bass reflex
Non-Magnetic shielding type
Driver
...........................................Woofer: 13 cm (5") cone type
Tweeter: 3 cm (1") aluminum dome type
Impedance
............................................................... Nominal 6 Ω
Frequency response
........................... 55 Hz - 45 kHz (–10 dB)
- 100 kHz (–30 dB)
Nominal input power
......................................................... 40 W
Maximum input power
.................................................... 120 W
Sensitivity
.........................................................87 dB/2.83 V, 1 m
Crossover frequency
....................................................... 2.8 kHz
Dimensions (W x H x D)
....................... 183 x 320 x 267 mm (7-1/4" x 12-5/8" x 10-1/2")
Weight
............................................................ 6.1 kg (13 lbs. 7 oz)
* Specifications are subject to change without notice.
* Care should be taken not to exceed the input power
values noted above.
Removing / Attaching the grille
Specifications
2
1
Banana plug
1
Tighten the terminal knob.
2
Simply insert the banana plug into the terminal.
• When removing or attaching the grille, be careful not to touch the drive
units, and not to exert excessive force with any tools.
• Do not touch or apply impact to the speaker’s diaphragm. Otherwise, the
speaker may malfunction.
Note
