42
The Network menu enables you to configure network parameters.
❑
Connection
Enables you to select a network connection method.
NOTE
• If other MusicCast-compatible devices are connected in Extend mode, “Extend(1)” or “Extend(2)”
will appear. For more information on the Extend mode, refer to page 21.
❑
Information
Displays the unit’s network information.
❑
IP Address
Enables you to configure the network parameters (such as IP address).
DHCP
This parameter specifies whether a DHCP server will be used.
Configuring the network parameters manually
1
Select “DHCP”.
2
Use the cursor keys (
/
) to select “Off”, and then use the cursor
keys (
/
) to select a parameter to configure.
3
Use the cursor keys (
/
) to select the edit position.
Use the cursor keys (
/
) to select a segment to edit.
4
Use the Cursor keys (
/
) to change the value.
5
Press SETUP to complete the setting.
Network
Wired
Select this option if you connect the unit to a network using a commercially-
available network cable (Page 18).
Wireless
Select this option if you connect the unit to a network via a wireless LAN
router (access point) (Page 22).
W.Direct
Select this option if you connect your mobile device directly to the unit. For
more information, refer to “Connecting a mobile device to the unit directly
(Wireless Direct)” (page 27).
NEW FW
Indicates whether an update for this unit’s firmware is available (Page 46).
STATUS
Displays the network connection status of the unit (except for Wireless
Direct connection).
MC NET
Displays the status of the MusicCast Network. If “Ready” appears, you can
use the MusicCast CONTROLLER app.
MAC
Displays the unit’s MAC address. MAC address varies depending on the
connection method (wired LAN connection or wireless LAN/Wireless Direct
connection).
SSID
Displays the unit’s SSID (only for wireless LAN or Wireless Direct
connection).
IP
Displays the unit’s IP address.
SUBNET
Displays the subnet mask
GATEWAY
Displays the IP address of the default gateway.
DNS P
Displays the IP address of the primary DNS server.
DNS S
Displays the IP address of the secondary DNS server.
Off
A DHCP server will not be used. You must configure network parameters
manually. For details, see “Configuring the network parameters manually”
below.
On (default)
A DHCP server will be used, and it will automatically obtain the unit’s network
parameters (such as IP address).
IP
Specifies the IP address.
SUBNET
Specifies the subnet mask.
GATEWAY
Specifies the IP address of the default gateway.
DNS P
Specifies the IP address of the primary DNS server.
DNS S
Specifies the IP address of the secondary DNS server.
Address1••192›
IP
(Example: IP address setting)
