Yamaha NEO'S 4 2008, Owner'S Manual

Page: 43 / 80

1. Engine oil drain bolt B
2. Strainer
3. Compression spring
4. O-ring
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compres-
sion spring, O-ring and engine oil
drain bolt B.
TIP
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to
their specified torques.
8. Refill with the specified amount
of the recommended engine oil,
and then install and tighten the oil
filler cap.
ECA11670
NOTICE
G
Do not use oils with a diesel
specification of “CD” or oils of
a higher quality than specified.
In addition, do not use oils
labeled “ENERGY CONSER-
VING II” or higher.
G
Be sure no foreign material
enters the crankcase.
1. Oil filler hole
9. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the cau-
se.
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
1
Recommended engine oil:
See page 8-1
Oil change quantity:
0.78 L (0.82 US qt, 0.69 Imp.qt)
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3 m • kgf,
16.6 ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2 m • kgf,
23.1 ft • lbt)
2 3 4
1
PERIODIC MAINTENANCE AND ADJUSTMENT
6-10
6
5C3-F819D-E0 6/2/09 13:03 Página 43