MU100
11
6.
Attach the XG Plug-in Board to the DB cover using the four (4), black screws that were removed in Step 3.
Install the XG Plug-in Board so that the side with the IC chips is facing the DB cover.
Position the XG Plug-in Board from above, onto the DB cover, making sure to align the holes of the board with the
holes on the lid. If the holes are not properly aligned, you may damage the plug-in board.
Side without the connector
Screw (black)
XG Plug-in Board
7.
Secure the DB cover back onto the MU100 by using the same four (4) silver screws that were removed in Step 2.
Secure the screws in the order shown in the illustration.
Arrange the cables of the
connector as shown, so
that they do not become
pinched or damaged.
Screw (silver)
1
2
3
4
