Yamaha MU100, Supplementary Manual

Page: 38 / 110

MU100 MIDI
39
2.4 Dump request
This message requests transmission of a specific block of parameter
values.
The output is the same as the bulk dump format.
2.4.1 XG dump request
This message requests transmission of all parameters of the
specified block of XG parameters.
The output is the same as the format of XG bulk dump (refer
to 2.2.1).
11110000 F0H Exclusive status
01000011 43H YAMAHA ID
0010nnnn 2NH N:device Number
01001100 4CH Model ID
0ggggggg GGH Address High
0mmmmmmm MMH Address Mid
0lllllll LLH Address Low
11110111 F7H End of Exclusive
Address is valid only when the beginning of the block has
been specified.
Reception/transmission of Dump Request cannot be turned
off by MIDI switches other than Exclusive = off.
2.4.2 MU100 native dump request (1)
This message requests transmission of all parameters of the
specified block of MU100 native parameters.
The output is in the same format as an MU100 native bulk
dump (refer to 2.2.2).
11110000 F0H Exclusive status
01000011 43H YAMAHA ID
0010nnnn 2NH
N:Device Number
01001001 49H Model ID
0ggggggg GGH Address High
0mmmmmmm MMH
Address Mid
0lllllll LLH Address Low
11110111 F7H End of Exclusive
Details are the same as for 2.4.1 XG Bulk Dump Request.
2.4.3 MU100 native dump request (2)
This message requests transmission of all parameter values
of the specified MU100 native parameter block.
The output is in the format of MU100 Native Bulk Dump
(refer to 2.2.3).
11110000 F0H
Exclusive status
01000011 43H
YAMAHA ID
0010nnnn 2NH
N:Device Number
01011001 59H
Model ID
0ggggggg GGH
Address High
0mmmmmmm MMH
Address Mid
0lllllll LLH
Address Low
11110111 F7H
End of Exclusive
Details are the same as for 2.4.1 XG Bulk Dump Request.
MIDI data format
3. Realtime messages
3.1 Active sensing
This message is used to prevent problems which could occur if a MIDI
cable were to be disconnected or broken during a performance.
When this message is received, the MU100 will begin monitoring the
state of the MIDI cable.
a) Transmission
not transmitted.
b) Receive
ReceptionOnce FE has been received, failure to receive any
MIDI message for an interval longer than approximately
300 msec will cause processing to be performed as if ALL
SOUND OFF, ALL NOTE OFF, and RESET ALL
CONTROLLERS messages were received, and the unit will
reset to a condition in which FE was never received.