Instrument and control functions
3-13
3
EAU12352
Pass switch “
”
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to “
”, the passing switch has no ef-
fect.
EAU12401
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12461
Turn signal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “
”
Press this switch to sound the horn.
EAU68270
Start/Engine stop switch “
/
/
”
To crank the engine with the starter,
set this switch to “
”, and then slide
the switch toward “
”. See page 5-1
for starting instructions prior to starting
the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU12735
Hazard switch “
”
With the key in the “ON” or “
” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12822
Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-26.)
1. Clutch lever
1
Summary of Contents for MTN690-A 2019
Page 98: ......