Yamaha MT09 2020, Owner'S Manual

Page: 64 / 112

Periodic maintenance and adjustment
8-12
1
2
3
4
5
6
7
8
9
10
11
12
To check the engine oil level
1. After warming up the engine, wait
a few minutes for the oil level to
settle for an accurate reading.
2. With the vehicle on a level surface,
hold it upright for an accurate read-
ing.
3. Look at the check window located
at the bottom-right side of the
crankcase.
TIP
The engine oil should be between the
minimum and maximum level marks.
4. If the engine oil is at or below the
minimum level mark, remove the
oil filler cap and add oil.
5. Check the engine oil filler cap
O-ring. Replace if damaged.
6. Install the engine oil filler cap.
To change the engine oil (and filter)
1. Start the engine and allow it to idle
for a few minutes to warm up the
oil, and then stop the engine.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap,
and then the engine oil drain bolt
and gasket.
TIP
Skip steps 4–6 if the oil filter cartridge is
not being replaced.
4. Remove the oil filter cartridge with
an oil filter wrench.
1. Engine oil filler cap
2. Engine oil level check window
3. Maximum level mark
4. Minimum level mark
1
2
3
4
1. Engine oil filler cap
2. O-ring
2
1
1. Engine oil drain bolt
2. Gasket
1 2
BS2-9-13.book 12 ページ ２０１９年７月２５日 木曜日 午前１１時１分