Yamaha MT07 TRACER, Owner'S Manual

Page: 59 / 102

Perio d ic maintenance an d a d justment
6-11
6
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11621

In or d er to prevent clutch slip-
pa g e (since the en g ine oil also
lu b ricates the clutch), d o not
mix any chemical a dd itives. Do
not use oils with a d iesel speci-
fication of “CD” or oils of a hi g h-
er quality than specifie d . In
a dd ition, d o not use oils la b ele d
“ENERGY CONSERVING II” or
hi
g her.

Make sure that no forei g n mate-
rial enters the crankcase.
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
TIP
After the engine is started, the engine
oil pressure warning light should go off.
NOTICE
ECA20860
If the oil pressure warnin g li g ht flick-
ers or remains on even if the oil level
is correct, imme
d iately turn the en-
g ine off an d have a Yamaha d ealer
check the vehicle.
11. Turn the engine off, wait a few
minutes until the oil settles, and
then check the oil level and cor-
rect it if necessary.
1. Torque wrench
Ti g htenin g torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 12 lb·ft)
Ti g htenin g torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 31 lb·ft)
Recommen d e d en g ine oil:
See page 8-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
2.30 L (2.43 US qt, 2.02 Imp.qt)
With oil filter cartridge replacement:
2.60 L (2.75 US qt, 2.29 Imp.qt)
1
UBC6E2E0.book Page 11 Tuesday, July 10, 2018 6:26 PM