Operation and important riding points
7-4
1
2
3
4
5
6
7
8
9
10
11
12
13
the throttle, and at the same time,
quickly pull the clutch lever in.
5. Shift the transmission into second
gear. (Make sure not to shift the
transmission into the neutral posi-
tion.)
6. Open the throttle part way and
gradually release the clutch lever.
7. Follow the same procedure when
shifting to the next higher gear.
TIP
When shifting gears in normal operat-
ing conditions, use the recommended
shift points.
EAU58270
To decelerate
1. Release the throttle and apply both
the front and the rear brakes
smoothly to slow the motorcycle.
2. At the recommended shift points
shown in the following table, shift
to a lower gear.
3. When the motorcycle reaches 25
km/h (16 mph), the engine is about
to stall or runs roughly, pull the
clutch lever in, use the brakes to
slow the motorcycle, and continue
to downshift as necessary.
4. Once the motorcycle has stopped,
the transmission can be shifted
into the neutral position. The neu-
tral indicator light should come on
and then the clutch lever can be
released.
WARNING
EWA17380
Improper braking can cause
loss of control or traction. Al-
ways use both brakes and apply
them smoothly.
Make sure that the motorcycle
and the engine have sufficiently
slowed before shifting to a low-
er gear. Engaging a lower gear
when the vehicle or engine
speed is too high could make
the rear wheel lose traction or
the engine to over-rev. This
could cause loss of control, an
accident and injury. It could also
cause engine or drive train dam-
age.
EAU64150
Recommended shift points
The recommended shift points during
acceleration and deceleration are
shown in the table below.
Shift up points:
1st
2nd: 20 km/h (12 mph)
2nd
3rd: 30 km/h (19 mph)
3rd
4th: 40 km/h (25 mph)
4th
5th: 50 km/h (31 mph)
5th
6th: 60 km/h (37 mph)
Shift down points:
6th
5th: 45 km/h (28 mph)
5th
4th: 35 km/h (22 mph)
4th
3rd: 25 km/h (16 mph)
B5Y-28199-11-E0.book 4 ページ ２０２２年９月６日 火曜日 午前１０時２８分
Summary of Contents for MT-10 2023
Page 132: ...B5Y 28199 11 E0 book 3...
