Quick Start Guide
MG10XUF Owner’s Manual
10
STEP 2 Getting sound to the speakers
1.
Make sure that the [
/ ] switch at the rear
panel is set to the [
] position (power off).
2.
Connect the supplied AC adaptor.
q
Connect the power adaptor with the gap of the
plug facing up, aligning it to the [AC ADAPTOR
IN] connector.
w
Turn the fastening ring clockwise to secure the
connection.
e
Plug the power adaptor into a standard house-
hold power outlet.
3.
Make sure that all switches on the unit are not
engaged (
).
4.
Turn on (
) the [PFL] switches for each channel
you are using.
NOTE
When you turn on the [PFL] switch for a channel, you can
monitor the signal for that channel through headphones con-
nected to the [Phones] jack. The level of the signal is also
shown on the level meter indicator, allowing you to more accu-
rately check signal levels. After checking levels, turn the [PFL]
switches off.
NOTE
When a [PFL] switch is turned on, the [PFL] indicator below
the level meter flashes.
5.
Turn all the level control knobs fully to the left (min-
imum) and lower all the faders fully. These include
the [GAIN] knobs (white), channel fader (white),
and [STEREO] fader (red).
6.
Set the equalizer knobs (green) to the center “
”
position.
7.
If you connect a device with high output level, such
as a CD player or an electric keyboard, to one of the
channels 1 to 4, turn on (
) the [PAD] switch of
the corresponding channel*.
NOTE
If you are using condenser microphones, turn on (
) the
[P48V] switch.
[
/
] switch
[AC ADAPTOR IN] connector
AC AD
APT
OR
IN
5
[GAIN]
6
Equalizer
5
Channel fader
5
[
STEREO]
fader
4
[
PFL] switch
Channel
[PAD] switch
Summary of Contents for MG10XUF
Page 26: ...MG10XUF Owner s Manual 26 ...
Page 27: ......
