Control panel
12
M2500—Owner’s Manual
■
GROUP/AUX FLIP switch= AUX (
)
The signals of AUX buses 7–14 will be sent to chan-
nels G1/A7–G8/A14 respectively, and will be output
individually from the GRP/AUX OUT G1/A7–G8/
A14 jacks.
D
PAN control
This adjusts the pan of the signal that is sent from the
G1/A7–G8/A14 section to the STEREO or MONO/C
bus. The function of the PAN control will change as
follows, depending on the setting of the channel
assign switch (
5
).
●
When the ST switch is on
PAN will adjust the pan of the signal that is sent from
each channel to the STEREO L/R bus.
●
When the LCR switch is on
PAN will adjust the pan of the signal that is sent from
each channel to the STEREO L/R bus and MONO/C
bus.
E
Channel assign switches
These switches assign the post-fader post-PAN signal
to the desired bus.
• ST (stereo) switch
If this switch is on (
), the post-PAN signal of the
output channel will be sent to the STEREO bus.
• MONO (monaural) switch
If this switch is on (
), the signal of the output
channel will be sent to the MONO/C bus.
• LCR switch
If this switch is on, the indicator above the switch will
light, and the post-PAN signal of the output channel
will be sent to the STEREO bus and the MONO/C
bus.
• MATRIX switch
IF this switch is on (
), the signal of the output
channel will be sent to the corresponding MATRIX
bus.
G1 / A7
ON/EDIT
AFL
10
10
20
30
40
60
50
5
0
5
PAN
L
C
R
MATRIX
ST
MONO
LCR
CHECK
ON
G2 / A8
ON/EDIT
AFL
10
10
20
30
40
60
50
5
0
5
PAN
L
C
R
MATRIX
ST
MONO
LCR
CHECK
ON
0
10
AUX5
AUX6
PRE
0
10
0
10
0
10
0
10
AUX7
AUX10
AUX9
AUX8
Note:
• The LCR switch takes priority over the ST/
MONO switch. If the LCR switch is on, the
post-PAN signal of the G1/A7–G8/A14 section
will be sent to the STEREO bus (L/R) and
MONO/C bus regardless of the on/off status of
the ST/MONO switch. (Refer to response curve
diagram 1 on page 4.)
• If the LCR switch is off, the ST/MONO switch
will function as a conventional channel assign
switch. If ST is on, the post-PAN signal of the
G1/A7–G8/A14 section will be sent to the ST
bus. If the MONO switch is on, the signal of
the G1/A7–G8/A14 section will be sent directly
to the MONO/C bus. (Refer to response curve
diagram 2 on page 4.)
