Operation
40
2.
After stopping the engine, disconnect
the fuel line or close the fuel cock if there
is a fuel joint or a fuel cock on the boat.
3.
Tighten the air vent screw on the fuel
tank cap (if equipped).
4.
Remove the key if the boat will be left
unattended.
NOTE:
The engine can also be stopped by pulling
the lanyard and removing the clip from the
engine stop switch, then turning the main
switch to “
” (off).
EMU27861
Trimming outboard motor
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
EMU27881
Adjusting trim angle
Power trim and tilt models
WARNING
EWM00750
●
Be sure all people are clear of the out-
board motor when adjusting the tilt an-
OFF
ON
OFF
ON
ZMU04600
1. Trim operating angle
1
ZMU01883
✩✱✣✬✤✧✲✣ ✧✣
©
2019 Yamaha Motor Corporation, U.S.A.
