Operation
70
EMU27889
Adjusting trim angle (Power trim and
tilt)
WARNING
EWM00754
Be sure all people are clear of the out-
board motor when adjusting the trim an-
gle. Body parts can be crushed between
the motor and the clamp bracket when
the motor is trimmed or tilted.
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instability
or control problems. Improper trim an-
gle can cause loss of control.
If equipped with a power trim and tilt
switch located on the bottom cowling,
use the switch only when the boat is at a
complete stop with the engine off. Do
not adjust the trim angle with this switch
while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“
” (up).
To lower the bow (trim-in), press the switch
“
” (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
1. Trim operating angle
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Power trim and tilt switch
DN
UP
1
ZMU07381
U6EK30E0.book Page 70 Wednesday, January 29, 2014 4:03 PM
