104
En
Troubleshooting
■
Remote control
■
HDMI
■
FM tuner
Problem
Cause
Remedy
See
page
The remote control does not
work and/or function
properly.
Wrong distance or angle.
The remote control functions within a
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front
panel.
30
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
30
Cannot operate external
components with the remote
control of this unit.
The external component you want to operate
is not selected as the input source.
Press INPUT on the front panel or the input
selector buttons on the remote control to
select the external component you want to
operate.
45
The remote control code was not correctly
set.
Set the remote control code correctly or try
another code for the same manufacturer
using the “List of remote control codes” at
the end of this manual.
96
Even if the remote control code is correctly
set, there are some models that do not
respond to the remote control.
Use the remote control supplied with the
external component.
—
The cursor buttons do not
work during SET MENU
operation.
The operation mode selector was
unwantedly set to TV/AV.
Set the operation mode selector to YSP.
—
Cannot use the My Beam
auto-adjust function.
Wrong distance or angle.
The remote control functions within a
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front
panel.
30
Error message
Cause
Remedy
See
page
Device Error
The number of the connected HDMI
components exceeds the limit.
Reduce the number of the connected HDMI
components.
—
HDCP Error
HDCP authentication failed.
Check that the connected HDMI
components support the HDCP copy
protection standards.
—
Problem
Cause
Remedy
See
page
FM stereo reception is noisy.
The characteristics of FM stereo broadcasts
may cause this problem when the
transmitter is too far away or the antenna
input is poor.
Check the antenna connections.
29
Try using a high-quality directional FM
antenna.
—
Use the manual tuning method.
49
There is distortion, and clear
reception cannot be obtained
even with a good FM
antenna.
There is multi-path interference.
Adjust the antenna position to eliminate
multi-path interference.
—
The desired station cannot
be tuned into with the
automatic tuning method.
The signal is too weak.
Use a high-quality directional FM antenna.
—
Use the manual tuning method.
49
Previously preset stations
can no longer be tuned into.
This unit has been disconnected for a long
period.
Preset the stations again.
50
