51
En
Troubleshooting
English
INTR
ODUCTION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
Notes
•
If the “ERROR” or “WARNING” message appears, resolve the problem and then run “Auto Setup” again.
•
Warning message “W-2” or “W-3” indicates that the adjusted settings may not be optimal.
•
Depending on the speakers, warning message “W-1” may appears even if the speaker connections are correct.
•
If error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
Unable to play
This unit cannot play back the songs
currently stored on your iPod.
Check that the songs currently stored on your iPod
are playable.
—
Store some other playable music files on your iPod.
—
Bluetooth™
Problem
Cause
Remedy
See
page
Searching...
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of the pairing.
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of establishing the connection.
Completed
The pairing is completed.
Canceled
The pairing is canceled.
BT Connected
The connection between the Yamaha
Bluetooth wireless audio receiver and the
Bluetooth component is established.
BT Disconnected
The Bluetooth component is disconnected
from the Yamaha Bluetooth wireless
audio receiver.
Auto Setup (YPAO)
Before Auto Setup
Error message
Cause
Remedy
See
page
Connect MIC!
Optimizer microphone is not connected.
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug HP!
Headphones are connected.
Unplug the headphones.
—
Memory Guard!
The parameters of this unit are protected.
Set “Memory Guard” to “Off.”
During Auto Setup
Error message
Cause
Remedy
See
page
E-1:NO FRONT SP
Front L/R channel signals are not
detected.
Check the front L/R speaker connections.
E-2:NO SUR. SP
Only a signal from one of the surround
channels are detected.
Check the surround L/R speaker connections.
E-4:SBR->SBL
Only right surround back channel signal
is detected.
If you connect only one surround back speaker,
connect it to the L-side (SINGLE) terminal.
Problem
Cause
Remedy
See
page
