Yamaha HTR-6030 Owner'S Manual Download Page 51

Page: 51 / 78

Set menu

ANCED

OPERA

ION

English

■

Speaker distance

C)SP DISTANCE

Use this feature to manually adjust the distance of each
speaker and the delay applied to the respective channel.
Ideally, each speaker should be the same distance from the
main listening position. However, this is not possible in
most home situations. Thus, a certain amount of delay
must be applied to the sound from each speaker so that all
sounds will arrive at the listening position at the same
time.

Unit

UNIT

Choices: meters

(m), feet (ft)

Initial setting:
[U.S.A. and Canada models]: feet (ft)
[Other models]: meters (m)
• Select “meters” to adjust speaker distances in meters.
• Select “feet” to adjust speaker distances in feet.

Speaker distances

Control range: 0.30 to 24.00 m (1.0 to 80.0 ft)
Control step: 0.10 m (0.5 ft)
Initial setting: 3.00 m (10.0 ft)

The available speaker channels differ depending on the setting of
the speakers.

■

Center graphic equalizer

D)CENTER GEQ

Use this feature to adjust the built-in 5-frequency band
(100Hz, 300Hz, 1kHz, 3kHz and 10kHz) graphic
equalizer for the center channel so that the tonal quality of
the center speaker matches that of the front speakers. You
can make adjustments while listening to the currently
selected source component or a test tone.

Control range: –6.0 to +6.0 dB
Control step: 0.5 dB
Initial setting: 0 dB

Press

to select a frequency band and

to adjust

the selected frequency band.

Following is an example where “100Hz” is selected as the
frequency band.

Test tone

TEST

Use this feature to make adjustments for “CENTER GEQ”
while listening to a test tone.
Choices:

OFF

, ON

• Select “OFF” to stop test tones and output the currently

selected source component.

• Select “ON” to output test tones from the center and

front left speakers.

■

Low-frequency effect level

E)LFE LEVEL

Use this feature to adjust the output level of the LFE (low-
frequency effect) channel according to the capacity of
your subwoofer or headphones. The LFE channel carries
low-frequency special effects which are only added to
certain scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.

Control range: –20 to

Control step: 1 dB

Speaker LFE

SP LFE

Adjusts the speaker LFE level.

Headphone LFE

HP LFE

Adjusts the headphone LFE level.

Depending on the settings of “BASS OUT” (see page 46), some
signals may not be output at the SUBWOOFER OUTPUT jack.

■

Dynamic range

F)D. RANGE

Use this feature to select the amount of dynamic range
compression to be applied to your speakers or
headphones. This setting is effective only when this unit is
decoding Dolby Digital and DTS signals.

Choices: MIN, STD,

MAX

• Select “MIN” (minimum) if you regularly listen at low

volume levels.

• Select “STD” (standard) for general use.
Select “MAX” (maximum) to preserve the greatest
amount of dynamic range.

Speaker dynamic range

SP D.R

Adjusts the speaker compression.

Headphone dynamic range

HP D.R

Adjusts the headphone compression.

SP DISTANCE