ENGINE
8. Assembly:
Pin
Packing the cylinder head cover
New
Cylinder head cover
See the "HEAD" on page 5-5
9. Assembly:
Hose air induction system
.
c. Turn the adjustment screw "3" in direction "a" or "b"
to obtain the specified valve clearance.
2
1
See "INDUCTION SYSTEM
AIR "on page 6-9
10. Assemble
Fuel tank
Side cover
Seat
Refer to "GENERAL CHASSIS"
on page 4-2
to
.
b
3
3
ADJUSTING THE ENGINE IDLE
NOTE:
Before adjusting the engine idling speed should be cleaned
the air filter element and the motor
Direction "a"
Increased valve clearance.
Direction "b"
Reduces valve clearance
1. Start the engine and allow it to warm a
minutes.
2. Install:
Digital Tachometer
(In the spark plug wire)
Tappet screw holder
YSST-706
Fitting key screw
YSST-806A
Hold the adjusting screw to prevent
move and tighten the nut to
specified.
Locknut
13 Nm (1.3 m · kg, 9 lb · ft)
d. Remeasure the valve clearance.
e. If the valve clearance is outside the value
....
specified, repeat the adjustment
,,,,
to obtain the specified clearance.
3. Check:
Engine idle
Off-spec
→
Set.
Engine idle
1300-1500 r / min
4. Fit:
Engine idle
a. Turn the throttle stop screw "1"
in direction "a" or "b" until it obtains
specified idle.
7. Assembly:
Access screw end of the crankshaft (along
with the O-ring
New
)
Screw access time stamp (along
with the O-ring
New
)
T.
R
3-4
