Yamaha FX140, Owner'S Manual, Page: 96 / 136

4-3
E
EJU19011
Lubrication
WARNING
@
Do not spray flammable rust inhibitor
products on engine surfaces while the
engine is hot. The sprayed substance or
propellants could catch fire.
@
1. Remove the rear and front seats. (See
pages 2-5 to 2-6 for seat removal and
installation procedures.)
2. Remove the air filter case cover
screws
1
, slide the locks
2
open, and
then remove the case cover.
3. Remove the air filter case cover and air
filter element.
4. Spray a rust inhibitor such as Yamaha
Stor-Rite Engine Fogging Oil into each
intake opening
3
for 3 seconds.
5. Install the air filter element and air filter
case cover.
6. Start the engine in a well-ventilated area
and let it run at idle for 15 seconds.
CAUTION:
@
Do not run the engine for more than
15 seconds. The engine could overheat.
@
7. Lubricate all cables such as the throttle
and steering cables.
NOTE:
@
Use a Yamaha Power Cable Luber and
Yamaha Lube-Zall to pressure lubricate the
cables and purge out any moisture between
the inner and outer cables.
@
8. Lubricate the areas of the watercraft
specified under Lubrication points on
page 4-17.
UF1B12.book Page 3 Monday, July 7, 2003 1:48 PM