FWX120 Operation Manual
181
8
Troubleshooting
Communication charges of the USB data
communication terminal are abnormal
Checking the provider
setting
Even if the USB data communication terminal
contract is a flat-rate system any use of it with
an incorrect configuration could be charged for
under the measured-rate system. In the “Basic
configuration page”, click “Advanced settings” -
“Detailed basic connection setting”. In the “Modify
provider” screen, check that the setting is correct.
Checking the
communication
history
If the Internet connection is made by the auto-
connect function, Internet connection may be
made automatically by software or a device of the
PC. Also, certain types of software are activated
automatically while the PC is starting. In this case,
outgoing calls may be generated automatically
without the user's knowledge. If the USB data
communication terminal contract is the measured-
rate system, you may be charged substantial fees.
To prevent this, check the communication history
frequently.
Be especially careful when you:
• Start using the product;
• Change any provider connection settings of the
product;
• Change the dial-up network setting of the PC;
• Install new software on your PC;
• Connect to the network with a new PC, network
equipment, or peripheral equipment;
• Update the firmware of the product; or
• Perform any different operations than usual
or sense a difference in the communication
response.
NOTE
• After canceling or changing your provider contract
please be sure to delete or reconfigure the connection
configuration of the product. Failure to observe
this could result in unexpected charges from your
telephone carrier or provider.
• Unexpected communication charges could occur
according to the status (change in access point,
maintenance, error, etc.) of the provider side. Please
be sure to pay constant attention to any notifications
you receive from your provider.
• The screen and settings used here may vary by
software version.
