Operation
82
TIP:
If the clip is not installed to the engine shut off
switch, the buzzer will sound when the
Start/Stop button is pressed.
EMU36510
Checks after starting engine
EMU41360
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
NOTICE
ECM02250
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU27670
Warming up engine
EMU41810
Electric start models
After the engine has started, warm up the en-
gine until the engine speed settles at idling
speed. The engine warming-up indicator is
shown on the Multi-Display while the engine
warms up. For further information, see page
51.
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU41820
Stop switches
Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
●
Check that the engine stops when the
main switch is turned to the “
” (off) po-
sition, or press the Start/Stop button.
●
Check that the engine stops when the clip
is pulled from the engine shut-off switch.
●
Check that the engine cannot be started
with the clip removed from the engine
shut-off switch.
ZMU07298
ZMU05848
6AW-9-18.book 82 ページ ２０１０年３月２２日 月曜日 午前１１時３５分
©
2019 Yamaha Motor Corporation, U.S.A.
