INSTRUMENT AND CONTROL FUNCTIONS
3-4
3
be traveled on a full tank of fuel. This in-
formation will enable you to plan future
fuel stops.
To set a mode
Push the “SELECT” button to change
between the odometer mode “ODO”,
and the tripmeter modes “TRIP 1” and
“TRIP 2” in the following order:
ODO
→
TRIP 1
→
TRIP 2
→
ODO
To reset a meter
To reset either tripmeter 1 or 2 to 0.0,
select either by pushing the “SELECT”
button, and then push the “RESET”
button for at least one second.
EAU11891
Tachometer unit
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
CAUTION:
ECA10031
Do not operate the engine in the ta-
chometer red zone.
Red zone: 11500 r/min and above
This tachometer unit is equipped with a
clock.
To set the clock
1. Push both the “SELECT” and “RE-
SET” buttons for at least two sec-
onds.
2. When the hour digits start flashing,
push the “RESET” button to set the
hours.
3. Push the “SELECT” button to
change the minutes.
4. When the minute digits start flash-
ing, push the “RESET” button to
set the minutes.
5. Push the “SELECT” button to start
the clock.
NOTE:
After setting the clock, be sure to push
the “SELECT” button before turning the
key to “OFF”, otherwise the clock will
not be set.
1. Tachometer
2. Tachometer red zone
3. Clock
U1C2E1E0.book Page 4 Wednesday, August 4, 2004 11:57 AM