8-90
8
Shimming (counter rotation model)
Shimming workflow
TIP:
• If the backlash is within specification, shimming is not required.
• When assembling the original inner parts and a new lower case, shimming is required.
• When replacing the pinion, forward gear, reverse gear, bearings, drive shaft, or propeller shaft
housing, shimming is required.
NO
YES
Shimming is not required.
YES
NO
Within specification?
Disassemble the lower unit.
Select the pinion shims (T3)
and propeller shaft shims (T4).
Assemble the lower unit.
Measure the backlash.
Adjust the forward gear shim
(T2) thickness and reverse gear
shim (T1) thickness.
Install the water pump assem-
bly.
Within specification?
Remove the water pump
assembly.
Measure the backlash before
disassembly.
Drive shaft and lower case (FL250G) / Shimming (counter rotation model)
Summary of Contents for F200B
