EMX660
18
INSPECTIONS
1.
Measuring Instruments
Low Frequency Oscillator:
Balance Output, Output Impedance = 150 ohms
Oscilloscope:
Input Impedance 100 kohms
Level Meter:
Input Impedance 100 kohms
Note: Use a balance input measuring instrument
: Signal level 0 dBs = 0.775V
2.
Mixer Part
2-1 Setting Conditions
Setting conditions are as follows unless otherwise specified.
2-2 Input and Output Load
Input Signal:
1 kHz, sine wave (Rs = 150 ohms)
Load:
All output terminals have a 10 k ohms load
2-3 Control Panel Setting
Channel Input (CH1-CH4) Section
EQ (HIGH, MID, LOW) level controls:
Center
MONITOR level control:
Maximum
EFFECT level control:
Maximum
LEVEL:
Maximum
PAD:
OFF
Channel Input (CH5-CH6) Section
EQ (HIGH, MID, LOW) level controls:
Center
MONITOR level control:
Maximum
EFFECT level control:
Maximum
LEVEL:
Maximum
EFFECT Section
DIGITAL EFFECT ON switch
OFF
MAIN Section
GRAPHIC EQUALIZER (7 band) Fader:
Center
EFFECT RTN level control:
Maximum
AUX IN:
Maximum
TAPE IN:
Maximum
MASTER (MAIN):
Maximum
MONITOR Section
GRAPHIC EQUALIZER (7 band) Fader:
Center
EFFECT RTN level control:
Maximum
TAPE IN Level control:
Maxmum
MASTER (MAIN) level control:
Maximum
Others
PHANTOM ON/OFF switch
OFF
POWER AMP switch
MAIN/MONITOR
>
=
>
=
Summary of Contents for EMX 660
