![Yamaha DSP-E800 Service Manual Download Page 17](http://html.mh-extra.com/html/yamaha/dsp-e800/dsp-e800_service-manual_895018017.webp)
DSP-E800
DSP-E800
14
No.6 DISPLAY CHECK
Check program for FL display. The display status will change as follows with sub-menu operation.
A defect of the FL drive port and FL display segments can be detected by using "All segments turn off" and "All
segments turn on".
A short-circuit between adjacent segments can be detected by using "Alternate segments turn on" (lattice form).
No.7 MANUAL TEST
By using the noise generator built into the DSP, test noise outputs to the channel specified by the sub-menu.
No.8 FACTORY PRESET
The initialization of the back-up RAM, which contains DSP program, set menu contents, etc. is reserved
or inhibited.
1. INHIBIT:
Inhibits initialization of the back-up RAM.
Using this option protect user set values.
2. RESERVED: Reserve to initialization of the back-up RAM.
(The RAM is actually initialized when power
is turned on next time.) This option is used for
the factory preset or to reset the RAM.
For the contents of the initialization, see page 18.
The protection data is also reset.
6. V F D
7. T E S T A L L
7. T E S T MA I N R
7. T E S T L F E
7. T E S T MA I N L
7. T E S T REAR R
7. T E S T CEN T E R
7. T E S T REAR L
Initial display
("6CH Ext" input)
("6CH MAIN IN" input)
Alternate segments turn on (lattice form)
Software Release date display
8. PRESET
8. PRESET RSRVD
CHCK
INHI
(Remote control code 7D-1D:"EFFECT" key)
The input becomes "6CH EXTERNAL" when all segments turn off and changes to "6CH MAIN IN"
when all segments turn on.
All segments turn off
All segments turn on