Yamaha Disklavier ENSPIRE DKC-900, Owner'S Manual

Page: 30 / 60

Getting Started
2
Chapter
24
Note:
If this product is connected directly
to your smart device, no Internet
access is available on your smart
device.
You can use this product as an access point to establish a direct wireless
connection between this product and your smart device.
1
Press the [ P ] (Standby/On) button to turn the power off.
2
Connect the USB wireless LAN adaptor (UD-WL01) to the
[USB] terminal on the rear of the switch box.
Note:
As a default, the [WLAN] switch is
set to the “RT” position.
3
Set the [WLAN] switch on the rear of the switch box to “AP.”
4
Press the [ P ] (Standby/On) button to turn the power on.
When this product is set as an access point, the LED lamp of the USB
wireless LAN adaptor (UD-WL01) lights up. You can now use this
product as an access point.
Note:
For details on the Wi-Fi setting,
refer to the owner’s manual supplied
with your smart device.
5
Open the Wi-Fi setting screen on your smart device.
6
Enable the Wi-Fi function.
Note:
[DKV**********] differs
depending on each Disklavier.
7
From the network list shown on the screen, tap on
[DKV**********].
Direct Wireless Connection
LED lamp
WPS button
[WLAN] switch