7
English
To remove discs
INSERTING CDS
1
Open the front panel, by pulling gently from both ends.
2
Slide the loader carriage to the desired slot number to
insert a disc.
3
Set the disc on the loader and flip the loader upwards.
Notes
• You can insert and remove discs while playing a disc.
– Do not set a disc in the slot of the disc being played (slot
indicator flashes). The disc in play is returned to its slot
when finished. If there is a disc in the slot of the disc at
play, when the disc is finished, “TAKE OUT” appears in the
display. Remove the disc from the currently playing disc’s
slot.
– Sometimes the front panel cannot be opened while a disc
is playing. In such case, wait a few moments or until the
disc stops playing then try again.
• Insert the CD correctly and avoid abrupt eject button
operation to prevent discs from popping out or falling into the
unit during operation.
Slot No. 0 (SINGLE) is reserved for single disc play
mode.
Notes
• Except when inserting or removing discs, keep your hands
out of the unit while the front panel is open. You could be
injured if your hands could become entagled in the
internal mechanism.
• Keep cassette tapes, video cassettes, or floppy discs
away from the magnetic latches.
Notes
• Do not use 8-cm (3-inch) CDs. Even if you use the
expander rings, the unit could be damaged.
• Do not put anything other than discs in the unit.
4
Close the front panel gently.
1
Open the front panel.
2
Slide the loader carriage to the slot of the disc you want
to remove.
3
Press the eject button on the loader carriage.
Note
• If you leave the front panel open while a disc is in play,
when the disc is over, the unit will stop.
With the Label side facing right
Flip this part upward.
Disc slots
Slot
number
Grasp here and slide.
Loader carriage
Magnetic
latch
Eject button
Loader carriage
CAUTION FOR CARRYING THIS UNIT
When you carry the unit:
1 Press STANDBY/ON and make sure “STANDBY”
disappears from the display.
2 Remove all CDs from the unit.
3 Disconnect the power cord from the AC outlet.
•
5