Yamaha CDC-835, Owner'S Manual

Page: 4 / 24

CONNECTIONS
●
Before making any connections, switch OFF the power to
the unit and the amplifier or other component.
●
Connections should be made to the correct input terminals
of the amplifier or other component.
●
If the placement of this unit causes noise to other
equipment, such as a tuner, separate them from each other.
●
If you use the DIGITAL OUTPUT (COAXIAL) terminal for the
connection, be sure to set the DIGITAL OUT ON/OFF switch
on the rear of this unit to the “ON” position. Otherwise, this
switch should be set to the “OFF” position.
4
To AC outlet
COAXIAL
DIGITAL OUT
ON OFF
2nd CHANGER
INPUT
MAIN 2nd
CONTROL
L
R
LINE OUT RELAY PLAY
COAXIAL
DIGITAL IN
CD
L
R
To AC outlet
This unit
Amplifier
Connection cord
When the LINE OUT (analog) terminals of this
unit are used (
➊
)
●
Be sure to set the DIGITAL OUT ON/OFF switch on the rear
of this unit to the “OFF” position.
●
Be sure that the left (“L”) and right (“R”) LINE OUT terminals
are connected to the corresponding (left and right) terminals
of the amplifier or other component.
●
Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have
such terminals, use the “TAPE PB” terminals. For additional
details concerning these connections, refer to the operation
instructions for the amplifier being used.
●
Adjust the level of signals output into an amplifier, etc. by
using the OUTPUT LEVEL control.
* Switching the DIGITAL OUT ON/OFF switch on the rear
panel resets the adjusted LINE OUT (analog) output level
to maximum.
When the DIGITAL OUT (COAXIAL) terminal of
this unit is used (
➋
)
●
Be sure to set the DIGITAL OUT ON/OFF switch on the rear
of this unit to the “ON” position.
●
Make the connection from this terminal to the digital input
terminal of an amplifier or D/A (digital-to-analog) converter
by using a connection cord.
●
The level of signals output into an amplifier is fixed to max.
and cannot be adjusted.
Choose one of the ways listed below to connect this unit to your amplifier.
Connection cord
(included)
➊
➋