Configuring the speaker settings automatically based on the
YPAO measurement results
Configuring the speaker settings automatically based on the YPAO
multi measurement results
Perform the following procedure to take a measurement when the “Multi Measure” option is selected. It
takes about 15 minutes to measure 8 listening positions.
NOTE
(
During the measuring process, test tones are output at high volume. You cannot adjust the volume.
(
During the measuring process, stay in a back corner of the room and note the following for accurate measurement.
(
Keep the room as quiet as possible.
(
Do not block sound between the speakers and the YPAO microphone.
(
Do not connect headphones.
(
YPAO multi measurement option cannot be enabled with wireless speakers.
1
Select the unit’s speaker impedance settings as necessary.
2
Configure the corresponding speaker settings.
3
Set the volume of the subwoofer to half. If the crossover frequency is adjustable,
set it to maximum.
VOLUME
HIGH CUT
CROSSOVER/
MIN
MAX
MIN
MAX
9
4
Place the YPAO microphone at your listening position (same height as your ears).
We recommend the use of a tripod as a microphone stand and adjust your listening position
(same height as your ears). You can use the tripod screws to stabilize the microphone.
98
PREPARATIONS > Configuring the speaker settings
