4
2.1. Connecting to the NETWORK [PC] Connector
Use an Ethernet cable (CAT5e or higher) to connect a computer or an access point to the
NETWORK [PC] connector. The following devices can be connected to the NETWORK [PC]
connector.
•
A computer running PM Editor
•
A Wi-Fi device for connecting StageMix (access point/router)
•
A Wi-Fi device for connecting MonitorMix (access point/router)
Do not connect any devices other than the above.
If there is more than one RIVAGE PM system, do not connect the
NETWORK [PC] connector of the RIVAGE PM systems to the same
network. Or do not share one access point with multiple RIVAGE PM
systems.
2.2. Configuring the NETWORK [PC] Connector for PM
Editor/StageMix/MonitorMix
Apply the appropriate settings to the NETWORK [PC] connecter to use PM Editor, StageMix,
and MonitorMix.
RIVAGE PM Editor
PM Editor does not require any specific settings between the NETWORK [PC] connector of
the RIVAGE PM DSP engine and the control surface.
Simply set the computer’s IP address within the following range to connect it with the installed
PM Editor.
IP Address
192.168.53.
1
– 192.168.53.
32
Subnet Mask
255.255.255.0
Summary of Contents for Audioversity Rivage Pm Series
Page 1: ...Network Setup Guide ...
Page 28: ......
