YDP-C71 Owner’s Manual
28
Appendix
E
NGLISH
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance
with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Remove all parts from the package and make sure you
have all of the items.
1
Attach (finger-tighten) C to D and E.
1-1
Untie and straighten out the bundled pedal cord.
Don’t discard the vinyl tie. You will need it later in
step 6.
1-2
Align D and E with each end of C.
1-3
Attach D and E to C by finger-tightening the long
screws
1
(6
20mm).
2
Attach B.
2-1
Place the lower side of B on each foot of D and E,
then attach the upper side to D and E.
2-2
Attach the top of B to D and E by finger-tightening
the thin screws
3
(4
12mm).
2-3
While pushing the lower part of D and E from
outside, secure the bottom ends of B using two
tapping screws
4
(4
20mm).
2-4
Insert the other two tapping screws
4
(4
20mm)
into the other two screw holes to secure B.
Have a Phillips-head (+) screwdriver of the
appropriate size ready.
D
A
B
C
E
Bundled pedal cord inside
AC Power cord
Assembly Parts
1
6
20 mm long screws
4
2
6
16 mm short screws
4
3
4
12 mm thin screws
2
4
4
20 mm tapping screws
4
5
Cord holders
2
Headphone hanger set
6
4
10 mm thin screws
2
Headphone hanger
L
1-2
1-1
1-3
E
C
D
Summary of Contents for Arius YDP-C71
Page 36: ...YCL XXX Owner s Manual ...
