![background image](http://html.mh-extra.com/html/yamaha/apex-rx10ltz/apex-rx10ltz_owners-manual_896460063.webp)
Periodic maintenance and adjustment
57
15. Install and tighten the oil filler cap.
16. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and make sure that the en-
gine oil drain bolt, oil tank drain bolt, and
the oil filler cap are installed correctly.
17. Turn the engine off, and then connect the
oil level gauge coupler.
18. Install the bottom panel and the right low-
er cover, and then install the right side
cover and the shroud.
NOTICE:
If oil is
leaking or the oil level warning indica-
tor comes on when the engine is run-
ning, immediately turn the engine off
and have a Yamaha dealer check the
snowmobile. Continuing to operate
the engine under such conditions
could cause severe engine damage.
[ECS00471]
ESU12015
Cooling system
The coolant level should be checked before
each ride. In addition, the cooling system
must be bled at the intervals specified in the
periodic maintenance and lubrication chart.
WARNING
EWS00380
Do not remove the coolant reservoir cap
when the engine is hot. Scalding hot fluid
and steam may be blown out under pres-
sure, which could cause serious injury.
When the engine has cooled, place a thick
rag or towel over the coolant reservoir
cap, and slowly rotate the cap counter-
clockwise to the detent. This procedure al-
lows any residual pressure to escape.
When the hissing sound has stopped,
press down on the cap while turning coun-
terclockwise and remove it.
To check the coolant level
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Remove the top cover. (See page 46 for
removal procedures.)
3.
Check the coolant level in the coolant re-
covery tank when the engine is cold. If the
coolant level is below the “COLD LEVEL”
mark, add coolant until it reaches the
“COLD LEVEL” mark. (See the following
section “Replenishing the coolant” for
more details.)
NOTICE:
If coolant is not
available, use distilled water or soft
tap water instead. Do not use hard wa-
ter or salt water since it is harmful to
the engine. If water has been used in-
stead of coolant, replace it with cool-
ant as soon as possible, otherwise the
cooling system will not be protected
against frost and corrosion. If water
has been added to the coolant, have a
Yamaha dealer check the antifreeze
content of the coolant as soon as pos-
sible, otherwise the effectiveness of
the coolant will be reduced.
[ECS00492]
U8FP15E0.book Page 57 Thursday, July 23, 2009 11:01 AM