AG-Stomp
32
ERROR MESSAGES
If an error occurs during operation, one of the following error message numbers will appear in the display.
Stop operation of the AG-Stomp and follow one of the solutions described below.
E1
: MIDI Receive Buffer Full
CAUSE:
Too much MIDI data is being received and the buffer is full
SOLUTION: Try reducing the amount of data being sent, or break the data into smaller blocks.
E2
: Communication Error.
CAUSE:
An abnormality is detected during MIDI communications.
SOLUTION: Check all connections, etc. and try again.
E3
: Bulk Receive Check Sum Error.
CAUSE:
The check sum does not match the received MIDI bulk dump data.
SOLUTION: Check all connections and transmitted data, and try again.
E4
: Bulk Receive Data Abnormality.
CAUSE:
An abnormality is detected while receiving the bulk dump.
SOLUTION: Check all connections and transmitted data, and try again.
Summary of Contents for AG-STOMP GA 011589
