4
En
English
This is the recommended installation procedure when
the material of the installation location is plasterboard.
1
Position the cutout template where you are
installing the speaker.
2
Trace a line around the template with a pencil.
The mark for the center of the hole is also
required.
3
Drill the pilot hole at the center mark made on the
ceiling.
W
ARNIN
G
• When using a drill or cutting tool, use safety goggles for eye
protection and be sure to observe all safety precautions.
4
To check the space behind the hole, insert a bent
sturdy wire (such as a coat hanger) into the hole,
and then slowly rotate the wire to check for any
obstruction.
• If there is any obstruction, patch the hole and select
another location.
5
Insert the tip of a keyhole saw into the pilot hole,
and then cut all of the way around the circular
outline.
W
ARNIN
G
• When using a keyhole saw or cutting tool, use safety goggles
for eye protection and be sure to observe all safety precautions.
6
Pull the speaker cable out of the hole which you
have cut.
• Leave some extra length of cable when pulling the cable
out.
7
Connect the speaker cable to the speaker.
• For detailed instructions, refer to page 6
“CONNECTIN
G
YOUR A
M
PLIFIER/RECEIVER”
.
8
Place the speaker into the ceiling.
CAUTION
• When installing the speaker, do not touch the tweeter dome
or woofer cone directly. This may cause a malfunction.
• Make sure that mounting clamps are turned inward when
installing the speaker in a ceiling.
How to install
3
60°
