20
YM-102
NOTE: To verify everything is
installed correctly, turn the exten-
sion counter clockwise. The notch
in the extension should not rotate
out of the detent block.
10. Rotate the extension clockwise
approximately 20° making sure not
to pull out the extension when rotat-
ing. This is only to aid in the instal-
lation of the actuator.
SNO-1247A
11. Install the actuator and secure using
the existing three torx screws.
Tighten to 0.4 kg-m, (36 in-lb).
12. Connect the harness to the gear posi-
tion sensor; then secure the connec-
tor to the main harness using a Cable
Tie.
13. Install the resonator and secure
using existing hardware.
14. Install the lower console; then install
the seat, hood, and both access pan-
els.
15. Start the engine; then shift the snow-
mobile into and out of reverse three
times.
Rear Suspension
This procedure should be done every 40
operating hours.
NOTE: Yamaha recommends that
low-temperature grease be used
for this procedure.
1. Using Handlebar Stand or Steering
Post Stand or a suitable substitute,
lay the snowmobile on its left side.
2. Lubricate all grease fittings with
low-temperature grease.
U8KCS1E0.book Page 20 Tuesday, May 16, 2017 5:42 PM
