Trouble recovery
99
cap. (See page 96 for information on the fuse
puller.)
(5) Securely install the fuse cover, and then
fit the bilge pump fuse holder into the rub-
ber cover.
(6) Secure the bilge pump fuse leads and
corrugated tube with the plastic ties.
(7) Securely install the engine cover and
seats in their original positions.
If the fuse immediately blows again, the elec-
trical system may be defective. If this occurs,
have a Yamaha dealer service the watercraft.
EJU34715
Towing the watercraft
WARNING
EWJ00811
●
The operator of the towing boat must
keep speed to a minimum and avoid traf-
fic or obstacles which could be a hazard
to the operator on the watercraft.
●
The towline should be long enough so
that the watercraft will not collide with
the towing boat when slowing down.
If the watercraft becomes inoperative in the
water, it can be towed to shore.
To tow the watercraft:
Use a towline that is three times the combined
length of the towing boat and the watercraft.
(1) Securely attach the towline to the bow
eye of the watercraft being towed.
(2) Sit astride the seat and hold on to the
handlebars in order to balance the water-
craft.
NOTICE:
The bow must be kept
up out of the water during towing, oth-
erwise water could flood the engine
compartment or water could flow back
into the engine, causing severe en-
gine damage.
[ECJ01330]
1
Bilge pump fuse holder
2
Fuse cover
3
Spare fuse
4
Fuse
Fuse amperage:
Bilge pump fuse:
3 A
1
Bilge pump fuse lead
2
Plastic tie
3
Corrugated tube
4
Rubber cover
2
1
4
3
2
1
3
4
1
Bow eye
1
UF2R12E0.book Page 99 Tuesday, July 6, 2010 9:21 AM
