Yamaha 2009 YZF-R1Y, Service Manual

Page: 89 / 526

CABLE ROUTING
2-52
1. Clutch cable
2. Main switch lead
3. Left handlebar switch lead
4. Steering damper lead
5. Horn lead
6. Horn
7. Brake hose
8. Front brake light switch lead
9. Throttle cable (decelerator cable)
10.Throttle cable (accelerator cable)
11.Right handlebar switch lead
12.Throttle cable
13.Steering damper bracket
14.Lower bracket
A. After passing the clutch cable through the
clutch cable guide, route it along and front
of the main switch.
B. Route the clutch switch lead outside of the
left handlebar switch lead.
C. Fasten the brake hose with the outer tube
of the front fork.
D. The clamp should be above the front brake
hose. The throttle cable (decelerator cable)
should be on the bottom and the throttle
cable (accelerator cable) should be above.
Fit the clamp toward outside rather than
inside.
E. 30–60 mm (1.18–2.36 in)
F. Route the front brake light switch lead
under the brake hose.
G. Route the right handlebar switch lead
above the metal fitting on the brake hose.
H. Route the throttle cable above the under
bracket, inside of the front fork and under
the brake fluid reservoir hose.
I. Fasten the plastic band inside of the front
fork. Fasten the band at position of the
main switch lead (white), left handlebar
switch lead (blue) and steering damper
lead (white).
J. Clamp the horn lead back and inside of the
lower bracket projection.
K. Lower bracket projection
L. Face the end of the plastic band to the left
and cut off the excess end leaving 2–4 mm
(0.08–0.16 in).
M. Outside of the vehicle.
N. Inside of the vehicle.
O. The main switch lead should be to the back
of the vehicle.
P. Front of the vehicle (The left handlebar
switch lead and steering damper lead can
switch sides.)
Q. Face the end of the plastic band to front
and cut off the excess end leaving 2–4 mm
(0.08–0.16 in).
R. 20–40 mm (0.79–1.57 in)
S. Cut off the excess end of the plastic band
leaving 2–4 mm (0.08–0.16 in). Connect it
at the position shown in the illustration.