Yamaha 2008 WaveRunner FX Cruiser High Output, Owner'S/Operator'S Manual

Page: 45 / 116

Features and functions
40
NOTE:
●
When the multifunction information center
starts operating, the analog speedome-
ter/tachometer makes one sweep, all dis-
plays light up for 2 seconds, and then the
meter starts to operate normally.
●
The multifunction information center will
continue to operate for 25 seconds after the
engine stops.
EJU34930
Analog speedometer/tachometer and indi-
cator lights
This watercraft is equipped with the following
meter and indicator lights.
EJU34941
Analog speedometer/tachometer
The analog speedometer/tachometer can be
used as a speedometer or a tachometer.
To switch between the speedometer and the
tachometer functions, push the “Speed/RPM”
button for at least 1 second when the multi-
function information center is operating.
The “SPEED” indicator light comes on when
the analog speedometer is selected. The
“RPM” indicator light comes on when the an-
alog tachometer is selected.
NOTE:
When the analog speedometer/tachometer is
switched to the speedometer function, the
“SPEED” indicator light blinks three times,
and then comes on.
Analog speedometer
The analog speedometer shows the water-
craft speed against water.
The large inner numbers on the meter show
the watercraft speed in miles per hour (mph)
and the small outer numbers show the speed
in kilometers per hour (km/h) when the speed-
ometer function is selected.
Analog tachometer
The analog tachometer shows the engine
speed (r/min).
The small outer numbers on the meter show
the engine speed when the tachometer func-
tion is selected.
1 Analog speedometer/tachometer
2 “SPEED” indicator light
3 “WARNING” indicator light
4 “RPM” indicator light
5 “UNLOCK” indicator light
6 “L-MODE” indicator light
1 “Speed/RPM” button
2 “SPEED” indicator light
3 “RPM” indicator light
UF1X12E0.book Page 40 Thursday, June 14, 2007 10:24 AM