4 - 27
CHAS
FRONT AND REAR BRAKES
NOTE:
_
•
While holding the brake hose, tighten the
union bolt as shown.
•
Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection
a
on the brake
master cylinder.
4. Fill:
•
brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
WARNING
_
•
Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
•
Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
•
When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the
boiling point of the brake fluid and could
cause vapor lock.
CAUTION:
_
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
5. Bleed:
•
brake system
Refer to
“
BLEEDING THE HYDRAULIC
BRAKE SYSTEM
”
in chapter 3.
Recommended brake fluid
DOT 4
a
Downloaded
from www.ScooterTime.net
