4
5. Preparation before use
1) Install the attached oil resisting hose at the oil
discharge port of the pump assembly. Screw the
hose completely by hand and tighten it with a
spanner so that it may not loosen. (Fig. 1)
2) Raise the pump handle and loose the 2 left and
right thumbscrews that fix the top-surface cover of
the oil tank. Then, shift the cover toward the right.
(Fig. 2)
3) Lower the handle and push it toward the right with
force to shift the handle position about 45ºC.
(Fig. 3)
When shifting the handle toward the right, step on
the footboard so as not to move the oil tank and
shift the handle by pushing the upper part of the oil
tank with a single hand.
4) Wipe the inside of the oil tank with a clean waste
cloth and change the applied oil. Take care not to
mix sand or dust in the oil.
5) Return the handle and the cover to their initial
positions and tighten the thumbscrews of the cover.
(Fig. 4)
6) Tighten the check valve provided on the right side
of the pump and operate the handle up/down to
bleed air in the pump and hose.
Continue this operation until oil is discharged from
the base.
Fig.1
Fig.2
Fig.3
Fig.4