![background image](http://html.mh-extra.com/html/yamada/ndp-40-series/ndp-40-series_maintenance-manual_894479004.webp)
1
1. Principles of operation
There are two diaphragms fixed to the center rod, one at each end. When compressed air is supplied to air
chamber b (right side, see Fig.1.1), the center rod moves to the right, the material in material chamber B is
pushed out, and at the same time material is sucked into material chamber A.
When the center rod is moved full-stroke to the right, the air switch valve is switched, compressed air is sent to
air chamber a (left side, see Fig.1.2), and the center rod moves to the left. The material in material chamber A is
pushed out, and at the same time material is sucked into material chamber B.
Through repetition of this operation, material is repeatedly taken in and discharged out.
2. Tools, etc.
2.1 General tools
·
Socket wrenches
13mm, 17mm, 19mm (except with the NDP-40 BP_, BV_),
24mm (BA_, BS_, BF_)
·
Hexagonal box wrenches
5mm, 6mm
·
Small crowbars
2 (B_C, B_N, B_E, B_V)
·
Open-end wrenches
17mm (NDP-40 BP_, BV_), 19mm (BA_, BS_, BF_),
24mm (BA_, BS_, BF_)
·
Plastic hammer
2.2 Special tools
·
PP wrench (sold separately)
·
Sleeve remover (sold separately)
Purpose: Removing the center disk Purpose: For removing sleeve
of BP_ and BV_ types
2.3 Misc.
·
Assembly oil
Turbine oil none addition class 1(equivalent ISO VG32 grade)
·
Nuts M16
X
1.5
·
Thread locker
·
Grease
Urea grease grade (NLGI) No. 2
3. Ordering Replacement parts
For accurate and speedy shipment of parts, be sure to order the right parts for your model to distributor.
Indicate the part numbers, descriptions, and quantities.