YAMADA 880307, Instructions Manual, Page: 4 / 12

1
1. Names and Materials of Parts
1.1 Names and Materials of Parts
1.2 Contents of Package
The main unit and accessories are packed separately in the box.
Please make sure no damage during shipment and no missing accessories after unpacking as soon as possible.
Please make sure no loose screws, piping connections, and fastener components.
Please retighten if any screws, piping connections, and fastener components are loose.
2. Preparations before Operation
CAUTION
- Apply sealing compound or sealing tapes to the male screws and tighten tightly when the pipes are
connected.
Be careful not to allow the sealing materials to enter the piping.
(However, no applying is necessary if it will be connected to the hose union.)
Check that there is no leakage from each part after connecting the piping.
<Assembly>
1) Connect high pressure hose and grease gun to the grease discharge port
of pump assembly and tighten with a wrench.
<To Fill Container>
2) Loosen stopper and draw latch to remove band. (Fig.1)
3) Separate lid together with pump assembly from container.
4) Remove follower plate from container.
<NOTE>
Prevent dirt particles from being sucked into the suction port or stuck to
follower plate.
5) Wipe off container with a clean cloth before filling it with grease. (Fig.2)
Pour grease into container while being careful not to mix dirt particles into
lubricant.
6) Smooth the surface of grease and then place follower plate on it in the
※
SK-55 (880307) does not include
carry assembly (851003).
Fig. 1
Fig. 2