FUEL SYSTEM
37
SRM-2620ES, SRM-2620TES
T262XS, C262S
T262TXS, C262TS
4-11 Replacing throttle cable and control parts
When throttle cable inner wire does not move smoothly, disconnect throttle cable from carburetor and
apply lubricating oil inside the cable. If it is still hard to move, replace throttle cable.
For SRM-2620ES, SRM-2620TES, T262XS and
T262TXS (L handle)
1. Referring to “3-5 Replacing ignition switch”, re-
move rear handle grip half.
2. Remove throttle trigger (G) with torsion spring
(H), throttle lockout lever (J) with torsion spring
(K), throttle cable (E), ignition switch (L) and corru-
gated tube (M) from rear handle. Check parts and
replace with new one if defective.
3. Pull out throttle cable (E) from corrugated tube
(M). Pass new throttle cable through corrugated
tube. Install all parts on rear handle (Refer to “3-5
Replacing ignition switch”).
For SRM-2620ES, SRM-2620TES, C262XS and
C262TXS (U handle)
1. Referring to “3-5 Replacing ignition switch”, re-
move right handle grip half.
2. Remove throttle lockout (N) and throttle trigger
(O) with torsion spring (P), throttle cable (Q), igni-
tion switch (R) and corrugated tube (S) from rear
handle. Check parts and replace with new one if
defective.
3. Pull out throttle cable (Q) from corrugated tube
(S). Pass new throttle cable through corrugated
tube. Install all parts on rear handle (Refer to “3-5
Replacing ignition switch”).
E
M
K
J
G
L
H
N
R
P
S
Q
O
4-12 Checking and adjusting throttle cable
1. Confi rm throttle plate (A) contacts tip (b) of throt-
tle adjust screw (B) when throttle trigger is in idling
position.
2. Make sure carburetor become WOT (wide open
throttle) when throttle trigger is fully squeezed.
3. Rotate the clip (E) on the throttle cable attach-
ment point so the vertical portion rests inside of the
groove and does not slide out.
NOTE:
The clip (E) position is critical as this
prevents the throttle cable from popping out.
4. If result of 1 and 2 is not suffi cient, loosen nut (C)
and adjust nut (D) to obtain correct position and
movement.
5. After confi rming throttle cable inner wire moves
smoothly when throttle trigger is squeezed, fasten
nut (C) to fi x outer throttle cable.
A
B
C
D
b
E
