Yalp Toro YA3805, Installation Instructions Manual

Page: 36 / 46

36
YA3805-201006
EN
NL
EN
A.10 Choose the installation type suitable for the
surface on which the Sona will be installed.
WARNING A surface mount can only be done
when the existing surface is made of at least 15
cm (5.9”) solid concrete.
DEEP mount (in existing ground): continue with
part B
SURFACE mount (on top of existing surface):
continue with part C
B. DEEP MOUNT
NOTICE Make sure the necessary preparations
have been made according to chapter A.
B.1 Dig out the holes for the anchors, according to
the indicated dimensions.
B.2 Align the moulds according to the dimensions
shown in the image.
B.3 Screw the anchors in place according to the
dimensions shown in the image.
B.4 Pour the concrete to the indicated height and
wait until it has hardened. One nut and washer
per anchor will stay in the concrete, this has been
accounted for in the amount of parts included in
the package.
B.5 Unscrew the upper nuts from the anchors and
remove the moulds.
NOTICE You can now continue the installation by
following the steps in chapter D.
C. SURFACE MOUNT
NOTICE Make sure the necessary preparations
have been made according to chapter A.
C.1 Align the moulds according to the image.
C.2 Drill three holes per mould according to the
instructions of the used chemical anchor.
C.3 Insert the chemical anchors according to their
instructions.
D. INSTALLATION
CAUTION The people installing the product
should wear the required protection and clothing.
D.1 Remove the polyester caps from the arches
and remove the protection material.
D.2 Fasten a nut to each anchor and add an
adjustment fl ange to each anchor.
D.3 Lift up the arch with the crane and lower it onto
the anchors. Make sure the main power cable runs
through the indicated hole. Fasten the arch to the
anchors, but do not fully tighten yet.
NOTICE Keep the arch supported until the two
arches have been connected on top.
D.4 Lift up the other arch and lower onto the
anchors. Fasten the arch to the anchors, but do not
fully tighten yet.
D.5 Align the tops of the arches by using the three
bolts at the bottom of each arch.
D.6 Connect the arches at the top, but do not fully
tighten yet.
D.7 Put the polyester caps in place by sliding them
on top of the arches.
D.8 Tighten the polyester caps to the steel frame
with the L-clamps.
D.9 Tighten all bolts/nuts on the top and the
bottom of the frame.
D.10 Connect the polyester caps to the top of the
frame.
D.11 Connect the speaker cables in the top of the
Sona.
D.12 Run the camera plate cable through the
cable protection tube inside the Sona, towards
the computer. Place the camera plate in place and
fasten.
D.13 Place the side plate with the button near the
computer. Connect all cables to the computer: A.
button, B. camera and C. power.