Yalp Memo, Installation Instructions Manual

Page: 63 / 86

63
YA3900-210727
EN
NL
DE
EN
• Connect the cable to the touchscreen unit
(push and twist) and screw the unit onto the
master post
• Screw the memo hat to the touchscreen unit
and push in the cap hats
• Mount the protection plate to the frame
• Mount the front plate to the frame
• Connect the Memo to the power supply
• Initialize the Memo by following step E.11
COMPUTER
F.12 disconnect the main power from the Memo
F.13 Unscrew the front plate and remove it.
F.14 Unscrew the protection plate and remove it.
F.15 Disconnect all cables from the computer.
F.16 Unscrew the computer and remove it.
F.17 Install the new computer:
• Place the new computer and mount it
• Connect all cables to the computer according
to step F.15
• Place the protection plate and mount it
• Place the front plate and mount it
• Connect the Memo to the power supply
• Initialize the Memo by following step E.11
SERVICE
SUPPORT
For questions, comments or help you can always
contact the Yalp head-office in the Netherlands:
Yalp
Nieuwenkampsmaten 12
7472 DE Goor
The Netherlands
+31 (0) 547 289 410
support@yalp.com
For contact details of Yalp distributors or offices,
please go to Yalp.com or check the distributors
overview at my.yalp.com.
POWER CYCLE
• Turn off the power or unplug the device
• Wait 30 seconds
• Turn on the power or plug in the product
• Wait until the product has completed the start-
up process and the product has come online
CLEANING & MAINTENANCE
WARNING Follow the instructions in this section
closely when servicing the product. Failure to
follow these instructions may cause serious injury
or damage.
WARNING Always be sure that the product is
powered off and unplugged before attempting to
perform inspection or maintenance.
WARNING When servicing the product,
use identical replacement parts only. Use of
unauthorized parts may cause serious injury or
damage.
• Use a mild soap and a non-scratching cloth to
clean the product every half year
• The product should be inspected for damaged
or missing parts on a regular basis
• When parts are damaged or missing, the
product should be disconnected and the parts
should be corrected, repaired or replaced to
prevent injuries
• Tighten the bolts every 6 months to prevent
loose bolts
• In case of surface corrosion: clean, sand and
repair with filler and paint