21
Default Settings
•
All devices (except SR-PC and SR-
PVC) are pre-set to “entry” mode.
When the system is first armed, users will have 30
seconds to exit the building. If the system is already
armed, triggering any sensors will cause an entry
countdown to begin.
SR-PC/SR-PVC’s default setting is “Burglar only”, i.e.
immediate triggering during full arm and sleep during
Part Arm. This is done to conserve battery life.
You can change the device behaviour and length of the
entry timer within the home app.
Burglar
Home Omit
Entry
Home Access
Disarmed
Part-Armed
Armed
Key
Burglar
Home Omit
Entry
Home Access
Disarmed
Part-Armed
Armed
Sensor
Ignored
Burglar
Home Omit
Entry
Home Access
Disarmed
Part-Armed
Armed
Instant Siren
Burglar
Home Omit
Entry
Home Access
Disarmed
Part-Armed
Armed
Triggers
Countdown
Supervision off as default (recommended).
Please note that having supervision enabled could reduce the battey life of your devices.
This feature should only be used by a professional installer to check for outage and malfunctions with
your devices. Incorrect usage would lead to a supervision failure message showing on the app.
With the exception of the PIR Image Camera, PIR Video Camera and Smoke Detector (these always
have supervision turned on), the other devices you will need to have supervision manually enabled on
the device if required.
Supervision can be enabled via Settings > System Settings > General Configuration.
Jamming and interference
detection (default on).
If jamming and interference is of concern, please
enable via “Controller” -> “Panel Setting”
