11/32
Door Must Not Bind
Door Must Not Sag
Door Must Not Be Warped
Door Must Swing Freely
Troubleshooting
1.
Check door for proper installation (see pictures to the right). Verify
1/8" between the latch and strike.
2.
Check hinges. They should not be loose or have excessive wear on
knuckles.
3.
If
Latchbolt will not deadlock:
Either strike is out of line or gap between door and jamb is too great.
Realign strike or shim strike out towards flat area of latchbolt.
4.
If
Latchbolt does not retract or extend properly:
Latchbolt tail and retractor may not be properly positioned.
A. Remove lockset. Look through 2-1/8" hole and verify latchbolt tail
is centered between top and bottom of hole.
B. Remove latchbolt and insert lockset. Look through latch hole and
verify retractor mouth is centered in hole. Adjust outside rose
plate if not. (See #5 on page 2)
C. Rebore holes if necessary to line up retractor and tail.
3
DUMMY TRIM INSTALLATION
Secure the Rose Support
assembly to the door using
screws and washers provided and
install the rose scalp and inside
lever.
A.
Insert key and rotate
70°.
B.
Depress retainer with tool provided.
C.
Slide lever off lock. (Also applies to inside
lever of 5417N, 5421LN and 5430LN lock
functions.)
clockwise
This lockset is designed to provide the highest standard of product quality and performance. Care should be
taken to insure a long-lasting finish. When cleaning is required use a soft,damp cloth. Using lacquer thinners,
caustic soaps, abrasive cleaners or polishes could damage the coating and result in tarnishing.
Finish Care
TO REMOVE CYLINDER HANDLE
TO REMOVE INSIDE HANDLE OF
5417LN AND 5418LN FUNCTIONS
(REMOVABLE CORE CYLINDER)
A.
Remove set screw.
B.
Slide handle off.
Do not over tighten set
screw when assembling.
5428LN, 5429LN and
5439LN Functions Only
Adjust for Door Thickness
Rotate 20°
Clockwise to
Remove Core
Control Key
Only Required to
Remove Cylinder
Set Screw Holds
Inside Handle
Double Cylinder
Function
A.
Remove retainer spring pad.
B.
Slide cylinder out of handle.
To reassemble reverse procedure. (Be sure
spacer is installed on back of cylinder plug.)
Water may be used to lubricate spring pad to
aid installation.
TO REMOVE CYLINDER FROM HANDLE
3
1
2
Lever
Handle
Retainer
Spring Pad
14-5407-9034
Yale #1802
Cylinder
For Yale 7 pin cylinder
cut to 11/32" as shown
Inside Lever
Rose Scalp
Inside Rose
Support Assembly
Machine Screws
Washers
An ASSA ABLOY Group brand
80-9150-0056-010 (01-13)
